Fuse Replacement; Mower Adjustments; Gauge Wheels - Snapper LT-200 Serie Manual De Usuario

Troubleshooting, Adjustment, & Service

Fuse Replacement

The fuse is a 20-amp blade type automotive fuse located
behind the battery on the steering tower. Replace only
with the same rated fuse, 20-amp.
To replace the fuse:
1. Open the hood and locate the fuse holder (B, Figure
36) and fuse (A). Attached to the steering tower.
2. Hold the fuse holder (B) and pull out the fuse (A).
3. Inspect the fuse for a broken connection. See Figure
37. Replace fuse if connection is broken. If you are
not sure if connection is broken replace fuse.
4. Hold the fuse holder (B) and insert new fuse (A) until
it is seated properly.

Mower Adjustments

Gauge Wheels (Select Models)
The mower gauge wheels can be placed in two positions
depending on the height of cut. When using higher cut-
ting heights, set the wheels in the lower position. When
using lower cutting heights, set the wheels in the upper
position. Do not allow wheels to remain on the ground
constantly while mowing. To adjust:
1. Remove the locknut (B, Figure 38), gauge wheel (C),
washers (D), and shoulder bolt (E). Change position
of gauge wheel to desired height.
2. Insert shoulder bolt (E) through washers (D) gauge
wheel (C), and gauge wheel bracket (A). Secure with
locknut (B). Repeat Steps 1 & 2 for all gauge wheels.
B
Figure 36. Fuse
A. Fuse, 20-amp
B. Fuse Holder
Solid Fusible Link
Figure 37. Blade Type Fuse
A. Good Fuse with Solid Fusible Link
B. No Good Fuse with Broken Fusible Link
B
C
Figure 38. Fixed Bracket Gauge Wheel Adjustment
A. Gauge Wheel Bracket
B. Locknut
C. Gauge Wheel
D. Washer
E. Shoulder Bolt
34
A
Broken Fusible Link
B
A
A
D
E