Sub-Zero PRO 48 Instrucciones De Instalación página 10

P R O 4 8
E L E C T R I C A L
A 220-240 V AC, 50/60 Hz, 10 amp circuit
breaker and electrical supply are required. A
separate circuit, servicing only this appliance,
is required. Locate the electrical outlet within
the shaded area indicated in the Installation
Specifications illustration on the previous
page.
The PRO 48 is equipped with a detachable
power supply cord with a 3-prong grounding
plug, which must be plugged into a mating
3-prong grounding-type wall receptacle. Follow
local codes and ordinances when installing the
receptacle.
IMPORTANT NOTE: A ground fault circuit
interrupter (GFCI) is not recommended and
may cause interruption of operation.
IMPORTANT NOTE: The PRO 48 is equipped
with an appliance inlet type device. This allows
easy replacement of the power cord. The appli-
ance inlet is located on top of the unit on the
compressor shroud.
10
I N S TA L L A T I O N I N S T R U C T I O N S
R E Q U I R E M E N T S
Do not use an extension cord or two
prong adapter. Electrical ground is
required on this appliance. Do not remove
the power supply cord ground prong.
The outlet must be checked by a qualified
electrician to be sure that it is wired with
the correct polarity. Verify that the outlet
provides 115 volts and is properly
grounded.
Always shut power off at the circuit
breaker before performing any installa-
tion, service or maintenance.