Preparation - Sub-Zero PRO Serie Guía De Instalación Y Especificaciones

SI T E P R E PA R AT I ON

Preparation

Uncrate the unit, and inspect for damage. Remove the wood
base, and discard the shipping bolts and brackets. Remove
and recycle packing materials. Do not discard the kickplate,
anti-tip bracket, and hardware.
Completely retract the front leveling legs to allow the unit to
be moved into position. The front and rear leveling legs can
be adjusted from the front once the unit is in position.
Remove the drain pan from the base of the unit to avoid
damage and to allow for proper placement of the appliance
dolly.
The grille assembly should be removed prior to moving
the unit. To remove, rotate the bottom of the grille upward.
Disconnect the network cable, then remove the center
mounting screw. Loosen the three grille bolts from the grille,
then pull the grille forward. Refer to the illustrations below.
Lift grille
SCREW
BOLT
CONNECTOR
Grille removal
Doors and drawers can be removed for ease of installation.
Door and drawer removal is not required. To remove a door,
refer to the illustration below. To remove a drawer, pull the
drawer out to full-extension. Apply forward pressure to
the front of the drawer slide, and pull up and back on the
drawer handle. Refer to the illustration below.
Door removal
DRAWER
SLIDE
Drawer removal
subzero.com | 7