Gree GCF220BKNA Manual Del Usuario página 24

the water in the tank
reduced without
humidifying operation
■ The water will be
naturally evaporated
when the unit is not
operating.
■ Pour the water in
the water tray during
purifying operation.
Water lacking indicator
light blink
No air outlet
Room dust (dust sensor)
indicator light is still ON
without change.
The water lacking
indicator light is still on
after the water fi lling.
There's peculiar smell,
but the indicator light is
on.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
The unit cannot humidify when the water is fi lled
●
in the tank.
The water in the tank do not reduce-please check.
The water will be slowly reduced when the
●
humidity is high or in the cold days.
The humidify operation will stop automatically
●
when the room humidity is too high under auto
humidify mode.
Is the ON/OFF indicator light is on?
●
―If not, press "ON/OFF" button.
Is the fi lter well assembled?
●
Is there dirt or scale on the fi lter?
●
―Maintain the fi lter.
If the water lacking indicator light is on?
●
―The water tray is not well assembled if the
light is on, correctly assemble the water tray.
If the set humidity is 10% higher than ambient
●
humidity?
The fl oater will swing as the water fl ows during
●
operation, result in the blinking of indicator
light. (The ON/OFF of the light is controlled by
the position of the fl oater)
―Fill water into the water tank.
If the fan motor is with malfunction?
●
―Please contact with GREE franchised store.
If the air inlet of the sensor is accumulated with
●
dust?
―clean the dust at air suction port with dust
collector.
Operate the unit a while after dust collecting.
Does the fl oater cannot move because of the
●
scale?
―Clear the scale with brush.
Is the water tray well assembled?
●
―Well assemble the water tray till a "click" is
heard.
Is the fl oater in water tray loosened?
●
―Assemble the fl oater as original sample.
If there's peculiar smell when the power plug is
●
connected?
After power plug is connected, the fi rst one minute
condition is considered as the sensitivity benchmark of
the peculiar smell sensor.
Pull out the plug when the unit is operating normally
without peculiar smell, connect the plug 3s later and
operate to modify the benchmark of peculiar smell sensor.
22