Operating Instruction - Drive PainAwayPro With Heat Manual De Instrucciones

Operating Instruction

The following steps are used to guide the device operation, and the details about each
step are listed in the following table.
st
1 Step – Check the battery in the control unit
The control unit comes with a built-in rechargeable
battery, and could be used as received. If the
battery icon on the turned-on control unit keeps
flashing, it means the battery is running out.
Charge the control unit with the enclosed USB
cable and AC adapter. USB cable could connect
to any certified adapters. The battery icon flashes
during charging, and becomes solid when the
control unit is charged fully.
2 nd Step - Install the electrode onto the control
unit
Place the enclosed electrode onto the back side of
the control unit using the magnetic snaps. Match
up the silver magnetic snaps on the electrode pad
with the silver magnetic snaps on the control unit,
follow the same steps for the gold. This should be
done before applying the device onto the skin of
treatment areas.
rd
3 Step - Place the electrode-installed device
on the stimulation-needed body area
Place the pad-installed device onto the treatment
area (such as the shoulder). Press down firmly
and ensure a firm contact with the body skin.
Note: Keep the skin clean before placing the
device.
4 th Step - Press the "ON/OFF" to turn on the
power
Holding the On/Off button could turn on the
device, indicated by the lit-up display on the front
of device. You could press and release the On/Off
button to lock/unlock the buttons on the device
front. When the buttons are locked, you could not
operate them. However, you still could turn the
device off by holding the On/Off button.
th
5 Step - Select one of the stimulation modes
Electrode installment
Place the device on the body area
13
Battery recharging