Installing Battery; Charging Battery - Soundcast VG3 Guia De Inicio Rapido

ENGLISH | How to use VG3
Congratulations and thank you for your purchase of the Soundcast VG3.
Please read the operation instructions carefully before use.
Quick Start Guide
Box Includes:
3.5mm Battery
analog Pack
audio
cable

Installing Battery

1. Using a Phillips #1 screwdriver, unscrew and
remove battery cover located on bottom of VG3
2. Connect the battery to the VG3 connector which
will only fit in the proper direction
3. Route the battery wires
4. Re-install battery cover
4

Charging Battery

Before initial use, charge battery for at least 5 hours to
full capacity. To ensure battery longevity and maximum
performance of the system, the battery should always be
charged prior to mobile operation.
(1)
Micro USB
charging
cable
1. Connect the included Micro USB charging cable
to the VG3 Micro USB port located behind the port
protection cover of the VG3
2. Connect the other end of the USB cable to
user-provided standard (1 Amp) or greater USB
charger. It is NOT recommended to charge VG3
using computer or laptop USB ports due to potential
compatibility or limited available charging current.
3. Included VG3 charging cable is rated for maximum
charging current and will provide fastest charge time
possible (4-5 hours) when used with a (1.5Amp) or
greater charger. Charging time may be increased
when using generic USB cables
4. Playtime varies from depending upon volume level.
Status
Power ON
Power OFF
Battery Low
Charging
Fully Charged
Fully Charged
Error- Cannot Charge
Orange Power/
Charging
Indicator LED
Power LED
Solid Orange
Off
Slow Blinking Red
Solid Red
Off (if power off)
Solid Orange (if power on)
Fast Blinking Red