Safety Instructions; Electrical Connection - Zanussi ZSG20100 Manual De Instrucciones

Ocultar thumbs Ver también para ZSG20100:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 90
Eggs in their shell and whole hard-boiled eggs should not be
heated in the appliance since they may explode, even after
microwave heating has ended.
The appliance should be cleaned regularly and any food
deposits removed.
Failure to maintain the appliance in a clean condition could lead
to deterioration of the surface that could adversely affect the life
of the appliance and possibly result in a hazardous situation.
The temperature of accessible surfaces may be high when the
appliance is operating.
The microwave oven shall not be placed in a cabinet unless it
has been tested in a cabinet.
The rear surface of appliances shall be placed against a wall.
Do not use harsh abrasive cleaners or sharp metal scrapers to
clean the glass door since they can scratch the surface, which
may result in shattering of the glass.
Pay attention to the minimum dimensions of the cabinet (if
applicable). Refer to the installation chapter.
The appliance must be operated with the decorative door open
(if applicable).

SAFETY INSTRUCTIONS

INSTALLATION
WARNING! Only a qualified person
must install this appliance.
Remove all the packaging.
Do not install or use a damaged appliance.
Obey the installation instruction supplied with
the appliance.
Always be careful when you move the appliance
because it is heavy. Always wear safety gloves.
Do not pull the appliance by the handle.
Keep the minimum distance from the other
appliances and units.
Make sure that the appliance is installed below
and adjacent safe structures.
The sides of the appliance must stay adjacent to
appliances or to units with the same height.

ELECTRICAL CONNECTION

WARNING! Risk of fire and electrical
shock.
All electrical connections should be made by a
qualified electrician.
The appliance must be earthed.
Make sure that the electrical information on the
rating plate agrees with the power supply. If not,
contact an electrician.
If the appliance is connected to the socket via
an extension cord, make sure the cord is
earthed.
Make sure not to cause damage to the mains
plug and to the mains cable. Contact the
Service or an electrician to change a damaged
mains cable.
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
17

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido