About.BAtteries; Installing Batteries; Checking The Remaining Battery Power; Removing Batteries - Roland Lucina AX-09 Manual De Usuario

Ocultar thumbs Ver también para Lucina AX-09:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 108
About Batteries
If you're operating the Lucina AX-09 on batteries, you'll need eight Ni-MH AA rechargeable batteries. The battery
life will differ depending on the conditions of use, but for continuous usage, it is approximately 4 hours.
About rechargeable batteries
When using rechargeable batteries, the battery lifespan will normally become shorter with each recharge cycle. If
the batteries run down soon after being recharged, it's time to replace them.

Installing Batteries

1. Switch.off.the.Lucina.AX-09's.power.(p ..8) .
2. Remove.the.cover.of.the.battery.compartment.
located.on.the.Lucina.AX-09's.bottom.panel .
While pressing the tabs of the cover, lift the cover up and
remove it.
3. Insert.the.batteries.into.the.battery.compartment .
Make sure to observe the correct polarity (+/– orientation)
for each battery when inserting it.
4. Replace.the.battery.compartment.cover .
* When.turning.the.unit.upside-down,.get.a.bunch.of.newspapers.
or.magazines,.and.place.them.under.the.four.corners.or.at.both.
ends.to.prevent.damage.to.the.buttons.and.controls ..Also,.
you.should.try.to.orient.the.unit.so.no.buttons.or.controls.get.
damaged .
* When.turning.the.unit.upside-down,.handle.with.care.to.avoid.
dropping.it,.or.allowing.it.to.fall.or.tip.over .
Note the following when using batteries
• Do not use alkaline batteries or zinc-carbon batteries.
• The Lucina AX-09 will not operate on batteries if the AC adaptor is connected.
• If batteries are installed, disconnecting or reconnecting the power cord at the AC outlet or disconnecting the DC plug from the Lucina AX-09's rear panel while the
power is on will cause the power to turn off. You must turn off the power before you connect or disconnect the power cord or AC adaptor.
• Do not allow any objects (e.g., flammable material, coins, pins); or liquids of any kind (water, soft drinks, etc.) to penetrate the unit.
• If used improperly, batteries may explode or leak and cause damage or injury. In the interest of safety, please read and observe the following precautions.
• Carefully follow the installation instructions for batteries, and make sure you observe the correct polarity.
• Avoid using new batteries together with used ones. In addition, avoid mixing different types of batteries.
• Remove the batteries whenever the unit is to remain unused for an extended period of time.
• If a battery has leaked, use a soft piece of cloth or paper towel to wipe all remnants of the discharge from the battery compartment. Then install new batteries.
To avoid inflammation of the skin, make sure that none of the battery discharge gets onto your hands or skin. Exercise the utmost caution so that none of the
discharge gets near your eyes. Immediately rinse the affected area with running water if any of the discharge has entered the eyes.
• Never keep batteries together with metallic objects such as ballpoint pens, necklaces, hairpins, etc.
6
Checking the Remaining Battery
Power
When the remaining battery power runs
low, three dots will blink in the display.
If this indication appears, replace the
batteries as soon as possible.
A while after this indication, the display will indicate "
and it will no longer be possible to operate the Lucina
AX-09.
You can also check the remaining battery power in the
following way.
1. Hold.down.the.[SHIFT].button.and.press.the.
[LOCK].button .
The display will indicate the remaining battery power as a
percentage ("0"–"100").
MEMO
• The remaining battery power indication is an
approximation.
• If you check the remaining battery power when the AC
adaptor is connected, the display will always indicate
"100. "

Removing Batteries

To remove the batteries, power off the Lucina AX-09, open
the battery compartment cover, and remove the batteries.
L o
, "

Publicidad

Tabla de contenido
loading

Tabla de contenido