Intended Use - Oase AquaMax Eco Twin 20000 Instrucciones De Uso

Intended use

AquaMax Eco Twin 20000 / 30000, referred to as "unit", may only be used as specified in the following:
• For pumping normal pond water for filter systems, waterfall systems and water course systems.
• Operate in accordance with instructions.
• Operation under observance of the permissible water quality. (→ Water quality)
The following restrictions apply to the unit:
• Do not use in swimming ponds.
• Never use the unit with fluids other than water.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
• Do not connect to the domestic water supply.
Installation
Only use the unit in its horizontal position and ensure stable installation on a firm ground. The unit must be positioned
below the water surface level. Attach the receiver flood protected at least 2 m away from the edge of the pond. For this
purpose, use the supplied ground stake or suspend the receiver by means of 2 screws. Do not open the receiver hous-
ing for this purpose. Ensure that the receiver is not exposed to direct sunlight. Fasten a traction rope to the strainer
bottom casing through the round openings. This allows you to pull the pump out of the water, if necessary.
Installation
Establishing the connections
 B, C
Recommendation for the use of the stepped hose adapter and hose connector:
• Pump outlet (1): Hose connector 2 " (alternative: stepped hose adapter 1 to 1½ ")
• Second inlet (2): Stepped hose adapter 1 to 1½ "
Push the hose clip and the union nut over the hose. Fit the hose on the stepped hose adapter or hose connector and
secure with the hose clip.
Fit the stepped hose adapter or hose connector on the pump outlet (1) or second inlet (2) and hand-tighten the union
nut.
Operate the unit with the pond filter.
 B
Connect the pump outlet (1) to the pond filter. Close the second inlet (2) with the cover (5) (delivery state).
Operate the unit with the satellite filter, or with the skimmer and pond filter.
 C
Connect the skimmer or satellite filter to the second inlet (2). For this purpose, remove the cover (5),
• Open the clips (6) and remove the strainer top casing.
• Press on the engagement hook (7) and take the cover out of the bottom strainer casing.
• Fit the supplied adapter.
• Put the filter top casing in place and close the clips (6).
• Connect the second inlet (2) to the satellite filter or skimmer. Connect the pump outlet (1) to the pond filter.
Install the receiver
 D
N O T E !
Do not permanently expose the unit to humidity/moisture.
Possible consequence: Damage to the unit.
Protective measure: Place the unit at a place protected from moisture/humidity, use protective cover.
• Fully insert the ground stake (11) into the soil.
• Place the receiver (10) on the ground stake.
• Check its stability.
- EN -
13