Installing The Base And The Printer - Kyocera MITA PF-8E Manual Del Usario

Alimentador de papel
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Installing the Base and the Printer

The printer is mounted on the upper deck of the base. See figure below.
Place the base onto a firm, sturdy table or desk.
1.
Align the positioning pins on the top of the base with the holes
2.
in the base of the printer, then slowly and carefully lower the
printer onto the base. You can easily set the printer on the
base by aligning the back edge of the printer with the end of
the base. Make sure that the connector on the base fits
squarely into the corresponding connector in the base of the
printer. See figure below.
Upper Deck
Connector
pf8-Eng.pm6
The table or desk must be larger than the base.
Base
7
Printer
Positioning Pins
Lower Deck for
the Feeder
12/19/00, 8:21 PM
7

Publicidad

Tabla de contenido
loading

Tabla de contenido