How To Maintain; Brushroll Belt - Eureka 4700 Serie Guia Del Propietario

Ocultar thumbs Ver también para 4700 Serie:
Tabla de contenido

Publicidad

20
ENGLISH

HOW TO MAINTAIN

The instructions in this booklet serve as a guide to routine maintenance. To
avoid unnecessary service calls, check the dust cup, belt, and brushroll often.
Brushroll
The brushroll turns as it sweeps and combs the carpet nap. Remove hair
and threads from the brushroll so it continues brushing the carpet. To
maintain the most efficient cleaning, the bristles must touch the carpet.
To test the bristle length, hold a ruler against the underneath side of the
cleaner. If the bristles no longer touch the ruler, replace the brushroll.

Brushroll Belt

Brushroll Performance Window (FIG. 19). To check condition of belt
FIG. 19a
watch to see if white dots on belt are moving through the performance
window (FIG. 19a). This indicates the brushroll is turning.
The brushroll belt turns the brushroll to agitate, sweep, and comb the carpet
nap. Check the belt regularly to be sure it is in good condition. Replace the
belt if it stretches, cracks or loses tension. Cut away any hair or threads
wound around the brushroll or the belt pulley because the buildup could
cause the belt to rotate unevenly.
FIG. 19
To Change Belt
CAUTION: Turn off the switch and unplug the electrical cord before
Step 1: Lower handle to floor to change belt.
Step 2: Remove two screws to release hood. Lift hood to expose belt and
Step 3: Lift left end of brushroll and pull out of base.
Step 4: Remove and discard belt.
Step 5: Clean debris from brushroll area.
Step 6: Place new belt around motor shaft.
Step 7: Place belt around right side of brushroll.
Step 8: Pull right side of brushroll to stretch belt. Secure right end cap
Step 9: Align left end cap with square in base. Push end cap into place.
Step 10: Rotate brushroll to position belt on brushroll pulley.
Step 11: Replace the hood.
Step 12: Tighten screws.
Use replacement belt, Style U 54312 or Style EXT-U 61120.
FIG. 20
(CONTINUED)
replacing belt. Motor shaft can become hot during normal
use. To prevent injury, avoid touching the motor shaft
when checking the belt (FIG. 20).
brushroll (FIG. 19).
into base.

Publicidad

Tabla de contenido
loading

Tabla de contenido