Electrical Connections - Dri-Eaz AirPath F366 Manual Del Usaurio

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PARTS INDENTIFICATION
High (II) / Low (I)
Switch
AirPath T
Wheels
Handle
Power
Cord
AirPath U
NDERSIDE
OPERATING INSTRUCTIONS
Setting Up
1.
Keep the air inlet and outlet grills clean and free of debris.
With the unit unplugged and turned off, look inside the fan
for any debris that has fallen in the fan chamber; carefully
dislodge debris if present.
07-01570B 03-06 Copyright 2007 Dri-Eaz Products, Inc.
(Shown, below)
Thermaformed
ABS Molding
Inlet Grill
Motor
V
OP
IEW
Outlet Grill
Fan Blades
V
IEW
2.
Unwrap the cord and plug the unit into a standard 115v
outlet. Caution! Be sure the unit is turned off before
plugging in.
Getting Started
1. To dry carpet, position the AirPath in the center of a 12 ft. x
12 ft. section to be dried.
2. Set the switch at the desired speed. Setting I is for low
speed and setting II is for high speed. Allow 15-20 minutes
of drying time per section. If the room is larger than 12 ft. x
12 ft. then move the unit to the center of the next 12 ft. x
12 ft. section of room for drying (see Drying Tips for
instructions).
3. Check for proper operation before leaving the unit
unattended. Do not move or carry the AirPath when it is
running. CAUTION! Do not lift the AirPath once the unit is
turned on, as it could result in injury.
Drying Tips
1. After drying first 12 ft. x 12 ft. section turn off the unit.
2. Unplug unit if the cord does not reach length of next
placement.
3. Pick up or roll the unit using the handle and move it to the
center of the next area (12 ft. x 12 ft. area) of carpet for
drying. NOTICE! Do not use the electrical cord to move or
position the unit.
4. Turn the unit to the desired speed (Low or High).
Transporting and Storing
1.
Use the handle to load or carry the unit.
2.
When transporting in a vehicle, secure the unit and strap it
into place to prevent sliding and possible injury to the unit
and vehicle occupants. NOTICE! Store securely to avoid
any damaging impact to the motor, blades, and other
internal parts.

ELECTRICAL CONNECTIONS

This unit is designed to operate on a 115V/60 Hz electrical
connection. Make sure that the electrical outlet is grounded
and that all safety precautions (outlined on page 1 of this
manual) are taken.
MAINTENANCE
Always turn off the power and unplug the unit before
performing maintenance procedures. WARNING! Turn off
and unplug unit before servicing or clearing obstructions.
Weekly Maintenance
Keep Unit Clean
: Keep outlet air vents clear of lint/dust
debris by vacuuming out as needed.
2

Publicidad

Tabla de contenido
loading

Tabla de contenido