Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR POWER
WARNING: Before servicing this heater be sure to unplug heater from wall outlet. Do
not only turn off heater from the main "ON/OFF" switch, be sure to unplug this heater.
This heater is for use on 120 volts only. The cord has a plug as shown in the following figure.
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, 60Hz circuit
with a properly grounded outlet is
required. The heater should be on
a dedicated circuit. Other
appliances on the same circuit
may cause the circuit breaker to
trip or the fuse to blow when the
heater is in operation. The unit
comes standard with a 6'
(1828mm) long three wire cord
exiting from the rear of the
fireplace.
WARNING: This heater has a voltage rating of
120 volts. The cord has a plug as shown in A. An
adapter as shown in C is available for connecting
three-blade grounding-type plugs to two-slot
receptacles. The grounding lug extending from the
adapter must be connected to a permanent
ground such as a properly grounded outlet box.
The adapter should not be used if a three-slot
grounded receptacle is available.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE
GROUNDED PLUG.
WARNING: Electrical
outlet wiring must comply with
local building codes and all
other applicable regulations to
reduce the risk of fire, electrical
shock and injury.
WARNING: Do not use this
fireplace if any part of it has been
under water. Immediately call a
qualified service technician to
inspect the fireplace and replace
any part of the electrical system if
necessary.
~ 5 ~
Publicidad
