Description Of The On-Off Remote Control - Novellini Una Manual De Instalación, Uso Y Mantenimiento

ENGLISH
Manual Whirlpool function:
Press and hold button 11 to adjust the intensity of the
Whirlpool massage. Simply release the button to apply
the new setting.
Automatic Whirlpool function:
The massage intensity is varied to create a pleasant mo-
dulating effect.
You can return from the hydromassage menu to the main
menu using button 12.
12
Airpool sub-menu:
Repeatedly press button 13 to select the Airpool function.
Disinfection menu:
Press button 2 on the main menu to access the disinfec-
tion menu.
To start disinfection, once the bath has been cleaned, fill
the bath with clean water up to the level used during nor-
mal use.
Fill the disinfectant tank (only on first use or when subse-
quently required), and press button 14 to release the sy-
stem.
Then use button 15 to start the disinfection process.
11
The pump will activate and the disinfectant soon begins
to circulate. After 4 minutes, the pump stops for about 20
minutes and then restarts for a further minute.
After this time, a symbol appears on the display to indica-
te that the bath is ready to be emptied.
If the image below is displayed at the beginning of the di-
sinfection process, and disinfection does not start, adjust
the level of disinfectant.
Another reason for the disinfection process to fail to start
may be that there is insufficient water in the bath. In this
case, the image below will be displayed.
Top up the bath with water to restart the disinfection pro-
cess.
13
Do not bathe in or use the water that has been
used for disinfection.
If the disinfection process is interrupted for any reason,
the disinfection symbol on the main menu lights up to
warn that disinfection has not been completed.
To cancel this warning, carry out a complete disinfection
cycle afresh.
Time adjustment menu:
From the main menu, press and hold the time button on
the display until the time adjustment sub-menu appears.
14
15
16 Press the + and - buttons to adjust the hours.
17 Press the + and - buttons to adjust the minutes.
18 Press to confirm and return to the main menu.
Draining:
In order to empty the pipes, the bath is equipped with a
drainage system.
• After a hydromassage, about 30 minutes after the bath
has been emptied, the blower is automatically activated
(for about a minute) to expel the water that has remained
in the pipes.
• When the bath has been used without a hydromassage,
drainage will need to be performed manually.
To do so, go to the hydromassage menu, and press and
hold button 6 for 4-5 seconds until the blower comes on.
The blower will stop automatically after 1 minute.
Alarm:
19 Communication failure between the central unit and
the remote control. Check that the power unit is switched
on.
If it is not, contact the service centre.
Description of the ON-OFF remote con-
trol:
Remote control functions:
The hydromassage can be started by pressing button 20
on the remote control. If there is enough water in the bath,
the pump will start.
Otherwise, the LED on the remote control will flash for
about 10 seconds.
Once the water level has been topped up, the hydromas-
sage will start automatically. To turn off the hydromassa-
ge, press 20.
Controlling the massage intensity:
The jet coming out from the nozzles is a WATER/AIR mix,
that is formed inside the nozzles by means of a suction
effect known as the "VENTURI EFFECT".
Press and hold button 21 to adjust the intensity of the
Whirlpool massage. Simply release the button to apply
the new setting.
37
16
17
18
19
21
20