How To Assembly The Housing & Light Kit - Fanimation The Multimax FP8008CH1 Manual Del Usaurio

How to Assemble the Housing and Light Kit
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the lower housing to the support bracket
using the two key slots in the lower housing.
Replace the third screw and securely tighten all three
screws (Figure 1).
2. Remove three screws from lower housing.
Assemble the light plate to the lower housing
and securely tighten all three screws (Figure 2).
2A. Don't install the light plate assembly if you don't
want the light kit. Assemble the decorative lower
housing cover to the lower housing by push and
snap in (Figure 2A).
3. Connect the 2-pin connector from the socket
plate assembly to 2-pin connector from motor
assembly (Figure 3).
4. Remove one of the three screws in the plate
assembly. Slightly loosen the remaining two
screws. Assemble the socket plate to the
lower housing using the two key slots.
Replace the third screw and securely tighten
all three screws (Figure 4).
Motor Assembly
Screws (3)
Lower
Housing
Light Plate
Assembly
Figure 2
Socket Plate
Assembly
11
Lower Housing
Figure 1
Lower
Housing
Decorative lower
housing cover
Figure 2A
Motor Assembly
2-PIN Connector
Socket Plate
2-PIN Connector
Figure 3
Lower
Housing
Socket Plate
Assembly
Figure 4