Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
14. INSTALL THE INTERIOR BLOWER (P8D BLOWER MODEL ONLY)
The blower must be installed to the insert using 8 no. 8 x 3/8" screws. Remove the cover from the blower assembly. Remove the
impellers by pulling them out gently (see pictures below).
HD0021
Install 4 no. 8 x 3/8" screws into the location as shown in the picture at
right. Do not tighten screws down fully, leave a 1/8" gap. Hang blower
unit onto insert inner top (screws through the large part of the keyhole).
Slide the blower to its position (screws in the small part of the keyhole).
Tighten the 4 screws.
Secure the blower by installing 4 more no. 8 x 3/8" screws into the
locations shown in the picture at right. Reinstall impellers and cover.
HD0022
HD0045
HD0081
- 9 -
Publicidad
Tabla de contenido
