How To Input String Value; Direct Access To The Previous Page; Alarms And Protection Parameters; Status Information - HUEGLI TECH HT DST4602 Manual De Uso

4.7.1.3

How to input string value

For some parameters you will have to set a value for the string data.
In this case, pressing ENTER
appears under the first character of the string. Using the LEFT
select which character to change. Then, use the UP
character selected. Repeat the procedure for each character that needs changing.
Use ENTER
4.7.1.4

Direct access to the previous page

You can open the last programming page displayed directly. This is possible if, when exiting programming
mode, instead of going back though the menus until you exit programming, you hold down EXIT
approximately 2 seconds.
The same is true when accessing the programming mode after Gen-set has automatically exited programming.
This is the case, if no programming operations are performed for 60 consecutive seconds or if the lockable
selector is switched to MAN or AUTO.
4.7.1.5

Alarms and protection parameters

WARNING!: Setting the trip time of the parameters to 0 disables the protection.
Protections and alarms can generally be configured using dedicated variables. Generally, the trip time can also
be configured.
4.7.2 Status information(S.xx)
In this way, information on the system status is provided.
You can scroll through the various pages using the LEFT
Page S.01 (STATUS) shows system status information. Part of this information is shown on the bottom status
bar.
The alarms page S.02 (ANOMALIES) is displayed automatically in the case of an anomaly. This page also
contains the diagnostic information on engines with the J1939 or MTU interface.
- alarms code, the message consists of a letter that identifies the alarm category (W - Warning, A - Lockout, D
– Power-off. See Chapter 3), an identification number, and the description of the alarm status.
- engine diagnostic codes, in accordance with standard SAE J1939 or MTU specifications. In the case of the
J1939 standard, when a signal is present the SPN and FMI fault's codes, the number of occurrences (OC), a
specific diagnostic code of the family of engines (DTC), and an explanatory text are displayed. For MTU
engines the SPN, FMI and OC are not shown, but the DTC code and an alphanumeric description are always
displayed.
Information!: For more information see document EAAM0380xxXA "Parameters table."
14
User's Manual HT DST4602
makes the square brackets [ ] around the variable flash, and a cursor
(confirm) or EXIT (abort) to end the procedure.
and RIGHT
and DOWN buttons to change the
and RIGHT buttons.
buttons, you can
for