Engine Measurements (E.xX); Pmcb(B.xX) Power Management Communication Bus - HUEGLI TECH HT DST4602 Manual De Uso

4.7.4

Engine measurements (E.xx)

The engine related measurements are shown in this mode.
Page E.01 (ENGINE) displays the main analog measurements of the engine read by the analog sensors.
Some engine measurements are only displayed if the CAN J1939, MTU system is configured.
Page E.02 (ENGINE COUNTERS) displays the partial and total meters of the engine.
Pages E.03 (TEMPERATURES), E.04 (PRESSURES/ENGINE TORQUE) and E.05 (AUXILIARY DATA)
(only displayed if the CAN J1939 system is configured, MTU) contain information on the temperatures,
pressures, levels, etc. of the engine. The number of pages displayed may depend on the type of engine set.
Page E.06 (FUEL PUMP) (displayed only if FUEL PUMP management is configured) contains information on
the fuel pump. The fuel pump management system can be modified in this page (see par. 6.2).
Pages E.07, E.08, E.09, E.10, E.11, E.12, E.13 and E.14 (EXTERNAL MEASUREMENTS) (displayed only if
the DITEMP/DIVIT expansion module/s is/are installed and/or the device inputs are configured for generic
measurements).
Information!: The analog inputs pre-assigned for main measurements do not come under this
category.
4.7.5

PMCB(B.xx) Power Management Communication Bus

Page B.01 (GEN-SET CONTROL MODULES ON PMCBUS) displays status information about the PMCB
(Power Management Communication Bus) network. This includes the number of network devices, the
operating mode of the load function, the identifier of the pilot generator and the list of priorities.
Page B.02 (GENERATORS) displays measurements (Power reference, Power delivery, Reactive power,
Operating hours and State) of power values for gen sets in the PMCBUS (Power Management
Communication Bus) network.
Page B.03 (TOTALS ON PMCBUS) displays measurements (Power reference, Power delivery, Reactive
power, Active energy and Reactive energy) for the sum of the energy produced by all the gen sets in the
PMCBUS(Power Management Communication Bus) network.
Page B.04 (LOAD MANAGEMENT) displays all the information relating to load management configuration on
the PMCBUS(Power Management Communication Bus) network.
WARNING!: Changes should only be made to the pilot generator by qualified personnel.
Press ENTER
generator.
Information!: See the following document for the meaning of the parameters: EAAM0380XX
(Parameters Table).
and the UP and DOWN buttons on this page to make changes to the pilot
User's Manual HT DST4602
17