Operation In "Manual With Recorder" Mode; Selecting Another Group - Nice planotime Instrucciones Y Advertencias Para El Instalador

Table 17

Selecting another group

1. Press key
2. Now you can use keys
Table 18 Assembling a multiple group and sending a command
Starting from the 1st group, press key
1.
group
2. Press key
3. Repeat the two previous steps to select other groups
4. When the multiple group has been assembled, you can use the following keys
to send the commands
Note: if you select and confirm the wrong group, you can delete it by repeatedly pressing key
eliminated starts flashing, then press key .
Table 19 Sending a special command to a group or multiple group
Starting from the 1st group, press key
1.
group
2. Press key
3. Repeat the two previous steps if you wish to select other groups
4. Press key
starts flashing
5. Press key
6. Now you can use the following keys
Table 20 Abandoning the "manual" mode and returning to the selection menu:
After sending a command, press key
Or:
Make sure that no group has been selected then press one of the following
keys:
them by pressing key
Or:
Press key
4.5) Operation in "Manual with recorder" mode Man
Table 21 Selecting the "manual with recorder" mode
1. Press key
2. Press key
3. Press key
From this moment you can use PLANOTIME as if it were in "manual" mode, except that all the commands transmitted
using key or , together with the day, hour and minute on which they were transmitted, will be memorized as events.
Note: the "manual with recorder" mode does not enable the recording of events containing the " " command.
A tip for the inexperienced: This operating mode is used to memorize events without having to program them
one by one. To record events that normally take place in the course of an entire week, access the "manual with
recorder" mode at the beginning of the week, then use PLANOTIME to command the daily up and down movement
of the automations every day at the desired time. At the beginning of the following week, set PLANOTIME to the "auto-
matic" mode; at this point the events will be repeated automatically through all the following weeks.
To delete an event recorded by mistake, see chapter 5.2.3.
repeatedly in order to select the desired group
to send commands to the selected group
to confirm the group
to confirm the group
repeatedly until the special command symbol "
to confirm the special command
(if necessary, select the groups by pressing key
)
repeatedly a number of times until Auto starts flashing
repeatedly a number of times until Auto starts flashing
twice until Man starts flashing
to confirm the "manual" mode with recorder
repeatedly in order to select another
repeatedly in order to select another
" or "
to send the special command
and deselect / select
Example
...
Example
...
until the group to be
Example
...
"
... or
Example
... Auto
Example
... Auto
Man
11
G