Memorizing Planotime As The First Transmitter; Memorizing Planotime As An Additional Transmitter; Abandoning The "Manual" Mode - Nice planotime Instrucciones Y Advertencias Para El Instalador

Table 5

Abandoning the "manual" mode:

After sending a command, press key
Or:
Make sure that no group has been selected then press one of the following
keys:
them by pressing key
Or: Press key
!
Warning: the code can be memorized in all the receivers found within the range of PLANOTIME; you should
therefore keep within range only the one involved in this operation.
All the memorization sequences are timed, which means that they must be executed within the set time limits.

2.3.1) Memorizing PLANOTIME as the first transmitter

When the code memory of the automation does not yet contain any codes, you can enter PLANOTIME following the
procedure described below:
Table 6 Memorizing PLANOTIME as the first transmitter
1. On PLANOTIME, select the group in which you wish to memorize the
automation, using the manual mode (Table 2)
2. Power the automation, you will immediately hear 2 long beeps **
3. Within 5 seconds, press and hold down key
(for approx. 3 seconds)
4. Release key
memorization
** If the memory of the automation already contains codes, when the unit is powered you will hear 2 short beeps; in
this case you must follow the instructions provided in the table below.

2.3.2) Memorizing PLANOTIME as an additional transmitter

If the code memory of the automation already contains other transmitter codes, you can enter PLANOTIME follow-
ing the procedure described below.
Table 7 Memorizing PLANOTIME as an additional transmitter
1. On PLANOTIME, select the group in which you wish to memorize the
automation, using the manual mode (Table 2)
2. Press and hold down key
the automation (after approx. 5 seconds)
3. Press key
slowly
4. Press key
Finally, 3 beeps coming from the automation will confirm that PLANOTIME has been correctly memorized.
If the code memory is full (14 codes), 6 beeps will warn you that PLANOTIME cannot be memorized.
6
(if necessary, select the groups by pressing key
)
repeatedly a number of times until Auto starts flashing
when you hear the first of the 3 beeps confirming the
on PLANOTIME until you hear a beep coming form
on a previously memorized and operational transmitter 3 times
on PLANOTIME once more
and deselect / select
on PLANOTIME
Example
... Auto
Example
3s
Example
5s