Settings Of Special Command - Nice planotime Instrucciones Y Advertencias Para El Instalador

5.4) Settings of special command "holiday" parameters
To ensure correct operation of the special command "holiday" the maximum admissible deviation value must be set; this
can be from 0 to 75 minutes, settable at intervals of 5 minutes. For example, if the value 15 is set, this means that an
event programmed for 08.00 can be performed randomly between 7.45 and 8.15.
The modification of this parameter affects all the events with this special parameter enabled.
Table 29 Setting parameters of special command "holiday"
1. Press key
2. Press key
3. Press key
4. Press key
5. Press key
6. Press key
7. Press key
5.5) Settings of special command "planetary time" parameters
To ensure correct operation of the special command "planetary time" the following parameters need to be set:
• Latitude of location with respect to the earth's equator, settable between 65° (towards North pole) and
(towards South pole) passing through 0° (equator).
To find the " " value to be entered, refer to the figure on the next page or a geographical map for a more pre-
cise location
• Difference between the time shown on the timer and the actual solar time; in practice the difference between mid-
day shown on the clock and the midday of the real solar time of the location "
minutes. The chapter "how to..." specifies a procedure to measure this value.
If a precise setting is not necessary, this parameter can be set to zero.
• Indication of whether the time is winter (solar time) or summer (legal time).
Table 30 Setting the parameters of the special command "planetary time"
1. Press key
2. Press key
3. Press key
4. Press key
command "planetary time"
5. Press key
6. Press key
7. Press key
8. Press key
and the actual solar time "
9. Press key
10. Press keys
(solar time)
11. Press key
These parameters should not be changed after entering one or more events with this special command enabled.
18
repeatedly until the text Auto starts flashing
three times to select programming mode Prog
to confirm programming mode
twice to select settings of parameters in the command "holiday"
to confirm settings of parameter "holiday" "
or to set the maximum deviation in minutes
to confirm the parameter
repeatedly until the text Auto starts flashing
three times to select programming mode Prog
to confirm programming mode
three times to select settings of the parameters in the special
to confirm settings of parameters in the command "planetary time"
or to set the location latitude "
to confirm the parameter
or to set the difference between the time shown on the clock
"
to confirm the parameter
or to select summer time "S" (legal time) or winter time "W"
to confirm the parameter
"
" can be set between 0 and ±99
"
Example
... Auto
or
-
65°
Example
... Auto
or
or
or