Publicidad
Idiomas disponibles
Idiomas disponibles
4 – INSTALLING THE FRONT PANEL
1- Unscrew the 2 retaining screws on the
front panel.
2- Open the front panel to gain access to the
front panel and control unit components
(Fig.1)
3- Disconnect the connectors of the NEXYS
board (do not forget the Green/Yellow
wire) (Fig.2)
4- Undo the 4 retaining screws on the
NEXYS board and remove it. (Fig.3)
5- On the assembled front panel, pass the
wiring harnesses through the cutout and
screw on the front panel using the 4
M6x10 screws (Fig.4)
Passing the cables through the cutout
This document is the property of SDMO INDUSTRIES. Any communication, reproduction or publication, in full or in part, is forbidden without written
CALL US TODAY
1-888-POWER-58
(Fig.1)
e.g.: NT2500 control unit
(Fig.2)
e.g.: NT2500 control unit
(Fig.3)
e.g.: NT2500 control unit
(Fig.4)
e.g.: NT2500 control unit
3/5
REQUEST A QUOTE
authorization from the owner
parts@genpowerusa.com
SHOP ONLINE
www.genpowerusa.com
Publicidad
