SDMO APM303 Manual Del Usaurio página 11

5 – WIRING
1- remove the existing cable ties.
2- Cable the counterparts of the new
wiring harness to the original
connectors (Fig.5). The other
wiring harnesses remain on
standby
3- Fit the relay base to the rail on the
control unit base plate (Fig.6)
4- Connect the voltage reference
wiring harness for the genset
wiring harness. The original
connector on the counterpart
(black MOLEX connector) and the
other one on the APM 303 (green
Phoenix contact connector) (Fig.7)
5- Secure all of the wires and wiring
harnesses and arrange them
lengthways in the channel (leave
the wiring harness connectors on
the side of the channel) (Fig.8)
This document is the property of SDMO INDUSTRIES. Any communication, reproduction or publication, in full or in part, is forbidden without written
CALL US TODAY
1-888-POWER-58
(Fig.5)
e.g.: NT2500 control unit
(Fig.6)
e.g.: NT2500 control unit
(Fig.7)
e.g.: NT2500 control unit
(Fig.8)
e.g.: NT2500 control unit
4/5
REQUEST A QUOTE
authorization from the owner
parts@genpowerusa.com
SHOP ONLINE
www.genpowerusa.com