SDMO APM303 Manual Del Usaurio página 12

6- Special case:
INHIBITING the charging alternator
alarm
6.1 Mitsubishi & some Lombardini
(KDI) engines
Connect the additional wiring
harness to the C3 connector,
removing the shunt from it (Fig.9)
Cable the other end (wire 61A) to
termination box B01 terminal 2
(Fig.10)
6.2 Lombardini engine (KDW1003
and 1404)
Clip the terminal with the resistor
onto the upper rail on the control
panel base plate
(Fig.11)
Connect the additional wiring
harness to the C3 connector,
removing the shunt from it
Cable the other end (wire 61A) to
termination box B01 terminal 2
Cable the other end (wire 80) to
termination box K4 terminal 3 (wire
80)
In all cases, refer to the diagram
This document is the property of SDMO INDUSTRIES. Any communication, reproduction or publication, in full or in part, is forbidden without written
CALL US TODAY
1-888-POWER-58
If it is non-operational, contact the SDMO after-sales service
representative for your area.
REQUEST A QUOTE
authorization from the owner
parts@genpowerusa.com
6.1
(Fig.9)
e.g.: NT2500 control unit
(Fig.10)
e.g.: NT2500 control unit
6.2
(Fig.11)
e.g.: NT2500 control unit
5/5
SHOP ONLINE
www.genpowerusa.com