Installation; Mechanical Installation - Festo DSMI B Serie Instrucciones De Utilizacion

DSMI−...−B
5

Installation

Mechanical installation

For electronically closed−loop control of the DSMI in combination with a positioning
controller:
Note
Special installation specifications apply to the electronically controlled
operation.
S To install the mechanical system, please observe the instructions in the
descriptions of the positioning controller.
The following applies to all applications:
Handle the DSMI with care so that the drive shaft is not damaged. This applies
S
in particular to the following:
Check whether it is necessary to drill addi
S
tional holes in the mounting flange of the
DSMI.
The grey areas (G) in the drawing show
where additional holes can be drilled
on the DSMI (e.g. to mount centring pins).
Position the DSMI so that you can easily reach the operating parts.
S
Fasten the DSMI with at least 2 screws.
S
Front mounting
Fig. 3
Festo DSMI−...−B 0806NH English
Rear mounting
(G)
Fig. 2
Side mounting
27