George Foreman GP200 Manual De Uso Y Cuidado página 15

WARNING!
• Empty the grease tray after each cooking session so excessive grease does
not accumulate. Failure to remove grease may result in a grease fire in the
tray or bowl.
• Never light the LP gas grill without the grease tray in place.
LIGHTING THE GRILL USING THE IGNITER
WARNING!
• Open the grill fully before lighting the burner to prevent an explosion from
gas buildup.
• Always inspect the regulator/tube assembly before each use. If it is bent, cut or
damaged, do not use the LP gas grill. Contact the manufacturer, as the regulator
assembly must be replaced with an assembly specified by the manufacturer prior to
the further use of the LP gas grill.
HOW TO LIGHT YOUR LP GAS GRILL
Note: If the flame is accidentally extinguished, repeat the procedure below for lighting the
grill. (See also TROUBLESHOOTING)
1) Open the lid and rotate the spring loaded level adjusters to the grilling position desired.
2) Push in and turn the regulator knob counterclockwise from the OFF/ LOCK position to
HIGH. (FIG 15A)
3) Push the igniter button several times so that it clicks each time. (FIG 15B)
4) Turn the regulator knob from "HIGH" to "LOW", while checking the flame through the
match light hole to make sure it is lit.
5) If burner does not light or igniter does not work, turn regulator knob to "OFF/LOCK".
Remove the cooking surface to dissipate the gas. Wait five minutes then repeat
steps 2 thru 4.
6) If burner still fails to light, repeat step 5, wait five minutes and refer to the
TROUBLESHOOTING page. If it fails to light, the burner can be lit manually, see Manual
Lighting of the Grill.
Fig. 15a
Fig. 15b
15