George Foreman GP200 Manual De Uso Y Cuidado página 5

• If the fire involves the cylinder, leave it alone, evacuate the area and
call the fire department.
• If there is any type of fire that threatens either personal safety
or endangers property, call the fire department.
8. Check the grease tray for grease buildup. Remove excess grease to avoid a
grease fire in the pan. Never use the grill without Grease Tray in place.
9. This installation must conform with local codes or, in the absence of local
codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54 Storage
and handling of Liquefied Petroleum Gases ANSI/NFPA 58 or CSA B149.1
Natural Gas and Propane Installation Code.
10. If an external electrical source is utilized, the outdoor cooking appliance,
when installed, must be electrically grounded in accordance with local codes
or, in the absence of local codes, with the National Electrical Codes, ANSI/
NFPA 70, or the Canadian Electrical Code. CSA C22.1.
11. Keep any electrical supply cord away from any heated surfaces. Electric
cords should be placed away from walkways to avoid a tripping hazard.
12. Combustible materials should never be within 36 in. of the back or sides of
your LP gas grill.
13. WARNING! Always Store LP Cylinders upright and where
temperatures do not exceed 125 degrees Fahrenheit. Never store a
spare or disconnected LP cylinder under or near this LP gas grill.
14. Check the LP gas grill for gas leaks and burner obstructions before
each use. WARNING! Do not use a flame to check for gas leaks.
See BEFORE USING YOUR LP GAS GRILL section of this manual for
correct leak test procedures. A clogged burner tube can lead to a
fire.
15. DANGER! If you see, smell, or hear the hiss of escaping gas from
the LP cylinder:
A. Get away from the cylinder.
B. Do not attempt to correct the problem yourself.
C. Call your local fire department.
16. WARNING! Do not operate an LP gas grill if you have knowledge
of or suspect a gas leak.
17. Always inspect the regulator assembly before each use. Always turn the
LP cylinder to the "OFF" position before inspecting parts. If it is bent, cut
or damaged, do not use the LP gas grill. Contact the manufacturer, as the
regulator assembly must be replaced with an assembly specified by the
manufacturer prior to further use of the LP gas grill.
5