Initializing The Interface; Final Assembly; Extra Features (Sync) - Metra 99-5838CH Instrucciones De Instalación

INITIALIZING THE INTERFACE

Attention! If the interface loses power for any reason, the following steps will
need to be performed again.
1. Refer to step 2 of "Installing the interface".
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type; "Ford Mustang 2015-2016".
b. Wait until the radio comes on, and the touchscreen display shows
"SWC Configured". This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn't come on within
3 minutes, and/or the touchscreen display does not show "SWC Configured", turn the vehicle
off and disconnect the 5838 harnesses from port "A" in the touchscreen display. Check all
the connections, reconnect the harness into the touchscreen display, and then try again.
4. Test all functions of the installation for proper operation, before reassembling the dash.

FINAL ASSEMBLY

1. Connect the USB cable attached to the radio trim panel with touchscreen display, to the
USB port in the back of the radio, if applicable.
2. Secure the completed assembly into the upper dash using the factory hardware removed in
step 12 of dash disassembly.
3. Snap the radio trim panel with touchscreen display over the completed assembly, and then
reassemble the dash in reverse order of disassembly.
EXTRA FEATURES
SYNC:
If the vehicle is equipped with SYNC, the 99-5838CH can retain this feature.
• Change the source of the radio to AUX-IN.
• Press the "Info" button on the touchscreen display to enter the SYNC menu.
Press the "HVAC" button to get back to the main menu.
13
REV. 9/28/2017 INST99-5838CH