Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove the lower torx screws
on either side holding the wind
deflector wings (only the lower two
need to be removed). (Figure A)
2. Remove (1) 3/16 Allen screw
securing each turn signal. (Figure B)
3. Remove (4) Phillips screws
from the windshield and set the
windshield aside. (Figure C)
4. Remove the top fairing trim clipped
to the top of the radio. (Figure D)
5. Unplug the turn signals.
6. Remove the speaker grills with a
panel removal tool and remove (1)
torx screw from each side.
(Figure E)
CAUTION: The fairing will be loose
at this point. Have a helper hold
it to keep from damaging it when
removing the screws.
Harley Road Glide 2015-Up Disassembly
(Figure A)
(Figure B)
(Figure C)
99-9700
7. Remove the fairing and set aside.
8. Remove (4) 3/16 Allen screws from
the sides of the radio.
Note: These screws will be reused
with the 9700 kit.
CAUTION: Be sure to hold the
radio when removing the last
screw so it will not drop.
9. Unplug and remove the radio.
10. Remove (2) Torx screws securing the
fairing bracket attached to the radio.
Note: This bracket will be reused
with the 99-9700 kit. Please note the
orientation of the bracket. The curved
portion faces the rear of the bike.
4
(Figure D)
(Figure E)
Publicidad
