Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Interface
With the key in the off position:
1. Connect the 99-9700 harness into the Axxess interface, and then to the wiring harness in the vehicle.
2. Connect the LCD screen into the Axxess interface.
Attention! To prevent error codes, all electronic devices including the headlight and turn signals must be connected
before proceeding to the next step.
Initializing the Interface
Attention! If the interface loses power for any reason, the following steps will need to be performed again.
1. Turn the key to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position, disconnect the interface,
check all connections, reconnect the interface, and then try again.
2. Program the LCD screen:
a. Pull the screen protector from the LCD screen.
b. Press and hold the "Return/ESC" button on the LCD screen for 5 seconds until "Select Interface" comes up.
c. Select "Connection Type", and then press "Enter"
d. Scroll up or down to "Direct Connect", and then press "Enter"
e. Once done, press "Return/ESC" to back out of that mode.
3. Test the radio and LCD screen for proper operation. Refer to "LCD Operation" for further information.
4. If installing an ASWC-1/AXSWC (sold separately): After your radio and LCD are functioning correctly. Leave the
ignition on. Plug in the 1/8" jack into the back of your aftermarket radio. Then plug in the 12-pin pre-wired
connector into the ASWC-1/AXSWC, begin tapping the volume up button on the handle bar controls for 10
seconds. Your handle bar controls are now programmed. Having Trouble? Please download the ASWC-1/AXSWC
troubleshooting guide from the Axxess website.
5. Turn the key to the off position.
99-9700
1. Reassemble the fairing in reverse order of disassembly.
* The included LCD screen provides oil pressure and EITMS status. For more information, please
see the owner's manual that came with the bike.
Main menu options:
• Red adjusts the red backlighting of the LCD (ranges from 1 to 32).
• Blue adjusts the blue backlighting of the LCD (ranges from 1 to 32).
• Green adjusts the green backlighting of the LCD (ranges from 1 to 32).
• Contrast adjusts the contrast of the LCD (ranges from 1 to 100).
• Reset puts the color back to the default settings.
Arrow Up - Toggles "up" through menu options
Arrow Down - Toggles "down" through menu options
Return/ESC - Return to the previous menu
Enter - Enter current menu option
7
Final Assembly
LCD Operation
Publicidad
