Hardware Kit; Wood Stud Installation - Mustang MV-STAT Intrucciones Para Las Instalación Del Montaje

A

HARDWARE KIT

x2 pcs
B
2" Wood Screw
x4 pcs
C
M4x12mm Philips
Head Screw
x4 pcs
M4x30mm Philips
Head Screw
TOOLS NEEDED
• Phillips Head Screw driver
• Electric drill and 1/4" (8mm) masonry bit for concrete/brick installation
Note: Use the magnetic level during installation and remove it when
1
installation is complete.
MOUNTING THE WALL PLATE

WOOD STUD INSTALLATION

Note: Use a wood stud finder to locate
the center of the stud and mark it with
a pencil. Drill a pilot hole at the
center 1/8" drill bit.
1. Place the wall plate against the wall
with the hook towards the bottom.
2. Secure the wall plate using one 2"
wood screw (A).
3. Using the level (E), carefully adjust
the wall plate until it is level.
4. Attach the remaining 2" wood screw
into the wall plate and tighten.
D
E
x1 pc
Bubble Level
System
2