Mustang MV-STAT Intrucciones Para Las Instalación Del Montaje página 3

CONCRETE/BRICK INSTALLATION
Note: 1/4"(8mm) anchor must be used for
concrete installation. They can be purchased at
your local hardware store.
1. Place the wall plate against the wall with the
hook towards the bottom.
2 .Level and mark with a pencil the two
mounting points found on the wall plate.
3. Drill two holes using an electric drill and 1/4"
masonry bit.
4. Insert the threshold anchors into the holes that
were drilled in the wall.
Note: If necessary, use a hammer to lightly tap
each anchor into place so that they are flat
against the wall.
5. Once the anchors are in place, put the wall piece
back over the concrete anchors.
6. Using a screw driver, attach the back plate by
threading the two screws into the anchor
which has been recessed into the wall.
7. Make sure all screws are snug, but be careful not
to over-tighten them.
2
ATTACHING THE ARM TO THE LCD
1. Determine the mounting hardware that is to
be used.
2a. If your LCD has a flat back, use the
M4x12mm
2b. If your LCD has a recessed back, use the
longer M4x30mm Phillips Head Screws (C)
and 3/4" spacers (D).
3. After you have determined the appropriate
screws, use them to attach the mounting
plate to the back of your LCD
4. Do not over-tighten the screws.
3
Philips Head Screws (B).