Pressure Washer Terminology; Assembly & Setup - Snap-On 870968 Manual De Instrucciones Para La Instalación, Uso Y Mantenimiento

Following are common terms associated with the use of Pressure Washers:
PSI: Pounds per square inch – common unit measure used for water pressure, air pressure,
hydraulic pressure and pounds of force.
GPM: Gallons per minute (liters per minute [metric]) – common unit measure used for flow
rate of water.
This Pressure Washer requires some assembly. If you have any problems with the
assembly of your Pressure Washer, please call the Pressure Washer helpline at
1-888-278-8092. If calling for assistance, please have the model, revision, and serial number
from the data tag available.
1. Using a box cutter, cut open the Pressure Washer carton on top.
2. Carefully remove all items from the box and inspect for completeness (see Functional
Description).
WAND / GUN CONNECTION
Insert the wand into the gun fitting outlet. Ensure
that the threads are aligned properly and that the
connection is secure. Securely tighten the nut by
hand.
PRESSURE HOSE/ GUN CONNECTION
CONNECTION
1. Remove and discard the protective plastic plug from the Pressure Hose Connector located on the rear of
unit.
2. Connect the pressure hose plastic fitting
to the Pressure Hose Connector. Ensure
that the threads are aligned properly and
that the connection is secure. Securely
tighten the nut by hand.

PRESSURE WASHER TERMINOLOGY

ASSEMBLY & SETUP
Unpack the pressure hose and connect the
metal fitting to the gun inlet. Ensure that
the threads are aligned properly and that
the connection is secure. Securely tighten
the nut by hand. Place the gun into the gun
holder on the side of the Pressure Washer.
PRESSURE HOSE / WASHER
10