Operating The Pressure Washer - Snap-On 870968 Manual De Instrucciones Para La Instalación, Uso Y Mantenimiento

GARDEN HOSE / WASHER CONNECTION
nected and turned on. Damage to equipment resulting from failure to follow this instruc-
tion will void warranty.
1. Before connecting the garden hose to the
Pressure Washer, connect the garden hose
to the water source and run water through
the hose to flush out any debris. Shut off the
water at the source.
2. Attach garden hose to the Pressure Washer
coupling inlet at the lower front of the unit. Ensure that the threads are aligned properly
and that the connection is secure. Securely tighten the nut by hand.
3. Turn on the water source.
water (less than 100 F) and adequate pressure (no less than 50 PSI).
POWER SUPPLY CONNECTION
KEEP all electrical connections dry and off the ground.
NEVER touch the plug with wet hands.
1. Connect the Pressure Washer GFCI power cord to a dedicated
electrical outlet.
2. To ensure for GFCI proper operation:
a. Plug into receptacle: indicator should be "ON"
b. Press Test Button: Indicator should be "OFF"
c. Press Reset Button for use. Do not use if test fails
DO NOT run the pressure washer without the water supply con-
For best result, use a short garden hose (30 ft. or less length), cold

OPERATING THE PRESSURE WASHER

Outlet capacity must be 120V, 60HZ and minimum 15 AMP.
2
11
3
Press Reset