Snap-On 870968 Manual De Instrucciones Para La Instalación, Uso Y Mantenimiento página 22

Problem
No water coming out of Wand
Unit does not reach
maximum pressure or pressure
is irregular
TROUBLESHOOTING GUIDE
Probable Cause
1. Clogged Nozzle.
2. Wand is attached incor-
rectly.
3. Clogged filter.
4. Kink in the Garden Hose
or Hose is wrapped on a
storage wheel.
5. Gun/Hose Assembly is
defective.
1. Diameter of garden hose
is too small.
2. Water supply is restricted.
3. Not enough inlet water
supply.
4. Garden Hose length is too
long.
20
Solution
1. Clean Nozzle (See instruc-
tions).
2. See instructions.
3. Clean filter (see instruc-
tions)
4. Unwrap the Garden Hose
and lay it out flat to ensure
that there are no kinks in
the Hose.
5. Remove Wand from the
Gun and squeeze trigger
to ensure that the water
is coming out of the front
of the Gun at a rate equal
to the Garden Hose. Call
Customer Service:
1-888-278-8092.
1. Replace with a 5/8 inch or
larger garden hose.
2. Make sure garden hose
has no kinks, leaks and
blockage.
3. Open water source fully.
4. Shorten the length of the
Garden Hose. We recom-
mend a maximum length
of 25 to 50 feet for City
water supply and 30 feet
for Well water supply.