Water Flow Adjustment; Using Spray Wand - Snap-On 870968 Manual De Instrucciones Para La Instalación, Uso Y Mantenimiento

ADJUSTING FOR FAN PATTERN
The angle of spray coming out of the nozzle may be adjusted by rotating the front
of the nozzle (cone). This will vary the spray pattern from approximately a 0°
narrow high impact stream (by turning the nozzle fully to the left) to a 60° wide fan spray (by
turning the nozzle fully to the right).
A narrow stream has high impact force on the cleaning surface and results in maximum deep
cleaning in a concentrated area. However, this narrow high impact spray must be used cau-
tiously, as it may damage some surfaces.
A wide fan pattern will distribute the impact of the water over a larger area, result-
ing in excellent cleaning action with a reduced risk of surface damage. Large
surface areas can be cleaned more quickly using a wide fan pattern.
WIDE
STREAM
ADJUSTING FOR PRESSURE
The Adjustable Pressure Nozzle allows you to vary the pressure of your spray by turning the
end of the nozzle (collar). Turning the collar fully to the right will reduce the pressure to its
minimum. If the Pressure Washer has a detergent tank system you must use this
minimum pressure setting in order to suction detergent.
Turning the collar fully to the left will increase the pressure to its maximum for greatest cleaning
efficiency. Turning the collar changes the pressure but not the fan pattern.
(turned) to low pressure position.
working pressure for your application, always start with lowest pressure setting and con-
tinue increasing the pressure until the best work result is achieved.
USAGE TIPS:
• For most effective cleaning, keep spray nozzle from 8 to 24 inches away from cleaning sur-
face.

WATER FLOW ADJUSTMENT

LOW
CONE
WIDE
STREAM
Detergent will NOT flow until the Pressure Adjust Collar is set
USING THE SPRAY WAND
To prevent damage to your surface and to select an appropriate
COLLAR
HIGH
13
LOW PRESSURE
HIGH PRESSURE