PEERLESS Mounts PRG-UNV Instalación Y Ensamblaje página 10

Attach adapter plate (B) to projector using one screw (J, K, L or M) for each channel as shown
6
below. Tighten all screws, while keeping the center of gravity. Be sure that adapter plate (B) is
straight. Adjust the feet of the channels to keep the adapter plate level. Tighten all screws with
4 mm security allen wrench (I) while keeping the center of gravity. If M3 screws (J) are used,
tighten using 2 mm security allen wrench (H).
NOTE: Projectors will require different size screws for mounting. Use a combination of screws
(J, K, L or M) and foot adjustment that will result in channels of adapter plate (B) fitting tightly
against projector. Important: In order to properly engage the threads in the mounting holes, the
screw must be turned at least 3 full turns.
NOTE: If using screw (J), place washer (G) between screw (J) and foot of channel.
CAUTION
• It is the responsibility of the installer to ensure
that the projector is properly ventilated. Feet
of channels are used to raise the mount off the
projector surface.
B
10 of 51
J, K, L or M
FOOT OF
CHANNEL
ISSUED: 09-30-09 SHEET #: 056-9024-1