Special Functions Common To Classic, Light And Full Configurations; Accessing And Using The Digital Compass - SCUBAPRO UWATEC Galileo Luna Manual Del Usuario

- maximum depth
- oxygen concentration
- nitrogen loading (via right bar graph)
- oxygen toxicity (via left bar graph)
Upon pressing the middle button (marked
"More"), the information in the left corner
changes in the following sequence:
- O %
2
- buddy tank pressure (only if Buddy
tank designation has been paired, see
section 1.11)
- (no-stop or decompression information
relative to L0 if an MB level between L1
and L5 is active, see section 3.5.3)
- ppO
2
Each time you press the button the
information changes to the next one in the
sequence and stays there until you press
the button again. If you press the button
while the ppO is displayed, the cycle starts
2
again from the oxygen concentration.
The stopwatch is reset and restarted by
pressing the left button ("BooK").
3.4 Special functions
common to CLASSIC,
LIGHT and FULL
configurations
3.4.1 Accessing and using the digital
compass
In all layouts, a press and hold of the
right button (marked "LiGHt") brings
up the digital compass display on your
computer screen. The display also shows
the depth, the dive time, the tank pressure
and the shortest between the no-stop
time and the RBT. In case of level stops
or decompression, the lower right corner
alternates every 4 seconds
decompression information
pressure together with RBT. A press and
hold of the right button from the compass
display returns to the computer display.
This also happens after the set auto-off
time defined in section 2.4.2.
F
NOTE:
If you are in compass mode when
Galileo is about to end the no-stop
phase, the screen will revert to the
regular computer display regardless
of the set auto-off time. Press and
hold the right button again if you wish
to return to the compass display.
In this lay-out, the button functions change
slightly. The middle button is now marked
"Set". Pressing this button will set the
bearing. Compass bearing represents
the direction the front of the computer is
pointed at. It is expressed in degrees, from
0 to 359. 0 degrees is North, 90 degrees is
East, 180 degrees is South, 270 degrees is
West and any other reading is interpolated
in between.
The message Set BearinG SucceSSfuL
will show on the display and a dot will appear
in the position of the set bearing. Setting a
bearing allows you to navigate towards a
between
reference direction. A press and hold of
and tank
the middle button will erase the set bearing.
Note that the set bearing stays in memory
until you either set a new one or erase it. All
set bearings are kept in the profile memory
and can be viewed with SmartTRAK after
downloading the dive to a PC.
3. diving with Galileo
51