SCUBAPRO UWATEC Galileo Luna Manual Del Usuario página 94

1. introduction to Galileo
interference-free line of communication
has to be established. This step has to be
performed only once for each transmitter
or when the battery in the transmitter is
replaced.
To pair Galileo to a transmitter proceed as
follows:
- Mount the first-stage regulator with the
Smart transmitter on a full tank.
- Turn on Galileo, ensure it is in the time
of day display and place it in direct
contact with the transmitter.
- Open the tank valve.
Upon pressurization, the Smart transmitter
sends a pairing sequence to Galileo.
When Galileo receives this information, the
display changes to show a listing of 2 tank
designations. The tank designations are t1
and Buddy. Tank t1 is your main tank.
The Buddy designation allows you to
receive tank pressure information from your
dive buddy's Smart transmitter (if equipped
with one) and to display it on the screen
of your Galileo (see chapter 3 for more
information).
Use the "" (left) and "" (middle) buttons
to select the tank that you want to assign
to the transmitter, then press "SaVe"
(right button). Galileo will confirm the
pairing with the message PairinG to t1
SucceSSfuL (or Buddy). If you do not
wish to complete the operation, press and
hold the right button and Galileo will show
14
the message PairinG canceLLed. The
pairing will also be cancelled if you do not
press "SaVe" within 3 minutes.
F
NOTE:
- The transmitter
been unpressurized for at least
40 seconds prior to the pairing
operation, else it will not transmit
the pairing sequence.
- A transmitter can only be paired
to one tank designation. If you pair
the same transmitter to a second
tank designation, the first one will
be erased. However you can pair
more than one Galileo to the same
transmitter.
- Pairing between Galileo and a
transmitter can be removed via
SmartTRAK.
After a successful pairing of T1 to Galileo,
the display will show the tank pressure in
either Bar or PSi. If tank T1 has not been
paired, Galileo will show no P instead of a
pressure value. If T1 has been paired but
Galileo is not receiving any signal, it will
show - - - instead of a pressure value.
On the surface, the status of the Buddy
tank is shown in the gas summary table,
discussed in section 1.12.
must have