Returning For Service - DeFelsko PosiTector DPM Guía Rápida

Before returning the instrument for service...
1. Install new batteries in the proper alignment as shown within battery
compartment.
2. Examine the surface temperature sensor for dirt or damage.
3. If the humidity sensor is slow to respond or reading erratically, recondition
the sensor by removing the probe from the gage body and wrapping it in
a damp cloth overnight.
4. Perform a Hard Reset. (see pg. 4)
5. If issue is not resolved, Update (pg. 10) your PosiTector gage body and
re-attempt measurements.
IMPORTANT:
If you must return the Gage for service, please fill out and include the
Service Form located at www.defelsko.com/support with the Gage. Be
sure to also include the probe, your company name, company contact,
telephone number and fax number or email address.
Limited Warranty, Sole Remedy
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole
or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTector and PosiSoft are trademarks of DeFelsko Corporation registered in the U.S. and
in other countries. Other brand or product names are trademarks or registered trademarks of their
respective holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.

Returning for Service

Returning for Service
and Limited Liability
and Limited Liability
www.defelsko.com
© DeFelsko Corporation USA 2018
All Rights Reserved
13