Returning For Service - DeFelsko PosiTector PC Guía Rápida

Returning for Service

Returning for Service
Before returning the Gage for service...
1.Install new or newly recharged batteries in the proper alignment
as shown within battery compartment (pg 10).
2.Examine the probe screen for dirt or damage (pg 5).
3.Perform a Hard Reset (pg 9) and a Zero (pg 6).
If you must return the Gage for service, describe the problem fully
and include measurement results, if any. Be sure to also include
the probe, your company name, company contact, telephone
number and fax number or email address.
Website: www.defelsko.com/support
Limited Warranty, Sole Remedy
Limited Warranty, Sole Remedy
and Limited Liability
and Limited Liability
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
www.defelsko.com
© DeFelsko Corporation USA 2014
All Rights Reserved
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole
or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTector and PosiSoft are trademarks of DeFelsko Corporation registered in the U.S. and in
other countries. Other brand or product names are trademarks or registered trademarks of their respec-
tive holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.
14