RAMSET RA27 Manual De Instrucciones De Funcionamiento Y Seguridad Del Operador página 16

DISASSEMBLY
6. Inspect all parts for wear or damage
and clean or replace as required.
Use detergent oil and cleaning brush.
Wipe parts dry before reassembly.
WEAR SAFETY GOGGLES WHEN
CLEANING TOOL PARTS.
7. Check the piston tip for mushrooming
or other deformities, and grind at.
The tip of the piston must be 90° to
the shank and grinding must only
be done by quali ed personnel. The
overall minimum length of the piston
must not be less than 6-1/8". When
less than this length, the piston must
be replaced to avoid tool damage.
8. Reassemble the tool in the reverse
order of disassembly.
ALWAYS PERFORM THE DAILY
FUNCTION TEST BEFORE USING
THE TOOL AFTER CLEANING
OR SERVICING.
DISASSEMBLY
16
USE BRUSH TO
CLEAN INSIDE BARREL
USE BRUSH TO
CLEAN OUTSIDE BARREL
5/16"
90°
GRIND PISTON TIP FLAT AND
BEVEL THE TIP EDGE AT 18°
6
7
8
18°