RAMSET RA27 Manual De Instrucciones De Funcionamiento Y Seguridad Del Operador página 7

Your Ramset RA27 Tool uses only the Ramset fasteners and loads shown below or
listed for the tool in the Product Catalog.
Never use any other types of fasteners or strip loads in the Ramset RA27 Tool. Use of other
types of fasteners or loads may cause unintentional load discharge, damage the tool, cause
poor fastening performance, or create a risk of serious injury to the operator or bystanders.
FASTENERS
.300 HEAD PLASTIC FLUTED DRIVE PINS
.145 Shank Diameter in Shank Lengths from
1/2" to 1-1/2"
TE DRIVE PINS
.157 Shank Diameter in Shank Lengths from
1/2" to 1-1/4"
CONDUIT CLIP ASSEMBLIES
LOADS
Ramset RS27 strip loads are specially made for use in the Ramset RA27 Tool.
RS27 10 SHOT STRIP LOAD
POWER CATALOG
LEVEL NUMBER
3 3RS27
4 4RS27
5 5RS27
DANGER
LOAD CASE
COLOR COLOR
Green Brass
Yellow Brass
Red Brass
FASTENERS / LOADS
.300 HEAD PLASTIC FLUTED DRIVE PINS
WITH 7/8" WASHER
.145 Shank Diameter in Shank Lengths from
POWER POINT
PLASTIC FLUTED DRIVE PINS
.150 Straight Shank in Shank Lengths
from 1/2" to 7/8"
.150 /.180 Step Shank in Lengths
from 1" to 1-1/4"
CEILING CLIP ASSEMBLIES
Ceiling Clip with 1" or 1-1/4" premounted
.145 Shank Pin and Ceiling Clip with 1" or
1-1/4" Premounted .150/.180 Shank Pin
The power level of the load is indicated by
the number marked on each box, the color
of the box, and the color on the tip of each
load. As the number increases, the power
level also increases.
Always perform the center punch test
described on page 3 to test the base material.
Always make a test fastening using the
lowest power level first. If more power is
required to set the fastener, use the next
higher power level until the powder level
necessary to drive the fastener is reached.
FASTENERS / LOADS
1" to 2"
7