RAMSET RA27 Manual De Instrucciones De Funcionamiento Y Seguridad Del Operador página 9

TOOL OPERATION
DAILY FUNCTION TEST
Always check the tool first to make sure
that it does not contain a strip load or
fastener. Test the tool several times by
depressing the muzzle bushing fully on a
hard surface and pulling the trigger. You
should hear an audible click as the ring pin
releases. Let up on the tool and check to be
sure that the barrel has opened to the full
open position.
OPERATING THE RAMSET
RA27 TOOL
1. After checking to be sure that the tool
is not loaded, point it in a safe direction
and be sure that the barrel is fully
extended. This assures that the piston
is in position for the next fastening.
2. With nger off the trigger, place the
fastener, point out, into the muzzle
end of the tool until the point end is
inside the muzzle. NEVER load a
fastener with your nger on the trigger.
DO NOT use excessive force when
inserting a fastener. STOP immediately
if excessive force is require, inspect
the barrel to nd out why the fastener
is not entering the muzzle freely. DO
NOT continue loading unless the
problem is corrected.
3. With the tool pointed in a safe
direction and nger away from the
trigger, insert a load strip into the
bottom of the handle and push it in
until bottom of the strip is equal to
the bottom recess in the handle.
TOOL OPERATING INSTRUCTIONS
PERFORM FUNCTION TEST WITH
BE SURE BARREL IS FULLY FORWARD
MUZZLE END OF THE TOOL WITH
INSERT LOAD STRIP INTO THE SLOTS IN
TOOL OPERATING INSTRUCTIONS
EMPTY, UNLOADED TOOL
INSERT FASTENER INTO THE
THE POINT OUT
THE RECEIVER HOUSING
9