General Safety Precautions; Spall Guard Usage Instructions - Nitroset NTS8X Manual Del Usuario

Safety Precautions

General Safety Precautions

Inspect the tool to ensure that the tool is complete, undamaged, and all parts
are secure prior to use. Damaged parts should be replaced using genuine
NITROSET® parts.
The trigger body and reset sleeve should be held in place when loading a fastener.
Insert the fastener assembly completely into the muzzle to ensure the
correct function of the tool. Fasteners that do not completely insert into the
muzzle should not be used and should be disposed of appropriately.
The NITROSET® tool should be reset after every actuation to clear any debris
from the nosepiece (muzzle+debris cup) of the tool.
Never leave a loaded tool unattended. Only load the tool prior to fastening.
Always remove fasteners and any debris from the muzzle prior to cleaning,
servicing, maintenance, or storage of the tool.
Always hold the tool securely and perpendicular to the working surface when
making a fastening.
Use the NITROSET® round or cut spall guard with clip to protect against concrete
spall.
Round Spall Guard
a
SPALL GUARD
CLIP
MUZZLE
DEBRIS CUP
For Pins & Pins with Washers

Spall Guard Usage Instructions

Install appropriate spall guard to nosepiece.
Round Spall Guard - Use with Pins & Pins with Washers
Spall Guard with Cut - Use with Fastener Assemblies with Clips
Ensure spall guard is installed flush to nosepiece.
Install the spall guard clip to the nosepiece to hold spall guard in place.
b
ROUND SPALL GUARD
DEBRIS CUP
W W W . N I T R O S E T . C O M
Spall Guard with Cut
SPALL GUARD WITH CUT
SPALL GUARD
CLIP
MUZZLE
For Clip Assemblies
4