Installation Instructions; Power Supply Connections; Installation On Wall - Eneo GLC-1701/IR Instrucciones De Instalación Y Manejo

Switch Description – GLC-1702
Name ON (down)
DSS is activated and sensitivity is raised
1
D/N
if the light intensity is reduced.
2
L/H Digital slow shutter with x6 image store

5. Installation Instructions

• Make sure the power is removed before installation.

5.1 Power Supply Connections

Camera can be operated with 12VDC only.
DC plug for all 12VDC cameras
5.2 Mounting

5.2.1 Installation on Wall

) Loosen three neck fastening screws (0) a little (but not completely) so that camera body can move.
) Secure the mount base () with screws supplied to the wall or ceiling.
Make sure that the cable is routed safely not to be damaged by the mount base (12) (see gap).
3) Separate the housing body () by loosening two rear cover screws (8) and place it at a safe area.
Make sure that the inside of the housing body (1) should not be contaminated by dust or liquid.
4) Set the camera direction roughly and fasten three neck fastening screws (0).
5) Apply the power to the camera.
6) Set the zoom (d) and focus (c) (see 5.3).
After setting zoom and focus, secure the knobs (d) and (c).
7) Adjust the parameters by using DIP switch setting.
8) Remove the power again.
9) Repeat step ).
This step is a preparation for an easy assembling for step 0).
OFF (up)
DSS switched OFF and camera behaves
like a normal camera.
Digital slow shutter with x3 image store
6
Rem.