Understanding Sensitivity And The Active Area; Programming A New Smartkey; Attaching Smartkey ™ To Collar - Petsafe HPA15-13808 Instrucciones De Instalacion Y Uso

1. Put the dog's collar on your leg just below your knee. Tape
may be used to secure the collar, if necessary. See A.
2. Stand directly in front of the SmartDoor
is approximately 2.5 feet (76 cm) from the SmartDoor
3. Put the SmartDoor
for operational instructions).
4. Put the SmartDoor
holding down the MODE-RESET and LEARN buttons at the
same time until all three lights flash once.
5. Turn the Sensitivity Knob counter clockwise to the
minimum position, then turn the Sensitivity Knob
clockwise until all lights begin to flash again.
6. Slowly continue to adjust the Sensitivity Knob clockwise
until you see a minimum of six consecutive flashes and
stop adjusting. Do not adjust higher than necessary.
7. Put the SmartDoor
at least 10 feet (3 m), allowing the door to automatically
lock. This may take up to fifteen seconds after the
SmartKey no longer is detected.
™
8. Now confirm the sensitivity level by approaching the
SmartDoor again. The door should unlock when you
™
step within approximately 2 feet (60 cm) in front of the
SmartDoor .
™
B. Understanding Sensitivity and
the Active Area
The Active Area is the area where the SmartDoor
consistently open based on your adjustment of the
sensitivity level. In the Fringe Area the SmartDoor
open inconsistently due to variables of radio-frequency
interferences or reflections. In the Inactive Area the door
will generally not unlock automatically. See B.
You may see slight differences between Outside and Inside
Active Areas due to radio-frequency interferences.
Depending on locationand application
C. Programming a New SmartKey
To reduce error while programming, remove the RFA-67 battery from all programmed SmartKey
accessories except the one you are programming. Press and hold the LEARN button until the
green light illuminates and begins to flash, now release the button. Bring the SmartKey
below the green light and the light will stop flashing and illuminate for two seconds. Now your
new SmartKey has been programmed and added to memory. If paired with an Iris
™
programmed key will show on Iris "Pets" screen and can be renamed. Up to five different
SmartKey accessories can be added one at a time to the SmartDoor
™
D. Attach the SmartKey
A split key ring has been provided to attach to your pet's
collar and should hang under the pet's neck.
The SmartDoor includes (one) SmartKey
™
pre-programmed and ready to use.
in the UNLOCKED Mode. (See page 6
™
in the Sensitivity Test Mode by
™
in AUTOMATIC Mode and step away
™
~ 2.5 feet (76 cm)
~ 6 feet (183 cm)
to the Pet's Collar
™
www.petsafe.net
so the SmartKey
™ ™
.
™
will
™
may
™
™
which comes
™
A.
B.
Door - Top View
Outside Inactive
Fringe
Active
Active
Fringe
Inactive
Inside
®
.
™
™
directly
™
System,
13