Migatronic OMEGA 3 YARD 300 Manual Del Usaurio página 12

BASIC control panel
Gas pre-flow (MIG/MAG)
Gas pre-flow ensures protection of the
weld from atmospheric air prior to welding. Gas pre-flow
time is the time from activating the torch trigger until
wire feeding starts. The gas pre-flow time is adjustable
between 0.0 and 10.0 seconds.
Soft-start (MIG/MAG)
Soft-start sets the initial wire feed
speed and improves the ignition characteristics. Soft-start
speed of the wire is adjustable between 0.0 and
18.0 m/min.
Burn-back (MIG/MAG)
Burn-back prevents the wire from
sticking to the weld pool at the end of a weld. Burn-back
is adjustable in steps between 0 and 30.
Gas post-flow time (MIG/MAG)
Gas post-flow time ensures protection
of the weld pool after welding and cools off the torch.
Gas post-flow time is the time from extinguishing the
arc to disconnecting the gas flow. Gas post-flow time is
adjustable between 0.0 and 20.0 seconds.
Spot time (MIG/MAG)
When the spot time function is active,
welding will stop automatically after expiry of the set spot
time. In MIG/MAG, it is possible to stop welding before
the spot time expires by pressing the torch trigger.
If the spot time is altered during welding, the alteration
has no effect till next welding. Spot time is adjustable
between 0.0 and 50.0 seconds. The spot time function
becomes inactive at 0.0 second.
User Menu
Press and hold the
the machine is ready to weld. Turn the left control knob
until the desired menu is displayed. Use the right control
knob to alter settings displayed in the right display. Press
the -key briefly to activate functions, such as gas test.
Functions and parameters in the user menu:
Press the
GAS test
Press the
If an IGC kit is installed, it is possible to adjust the gas flow
with the right control knob.
12
-key to open the user menu, when
-key to exit the menu.
-key to open and close the gas valve.
IGC status and calibration
Visible only if IGC kit is installed.
Press the -key to start IGC calibration.
Use the right control knob to switch between manual and
synergic gas control if a synergic MIG program is selected:
0: Manual gas control
1: Synergic (IGC) gas control
Setting remote control
Use the right control knob to change the following
settings:
0: Disabled
1: Dialog torch
2: Analogue remote control
4: MIG-A-Twist V2 (November 2010)
5: MIG-A-Twist V1
6: ERGO2 1–7 sequences
7: ERGO XMA 1–3 sequences
Options menu for machine settings
Visible only if one or more of the options menus
are supported by the machine.
Press the
and return to the main menu.
Long Cable Compensation - status and
calibration
Press the -key to start cable calibration.
Use the right control knob to enable/disable Long
Cable Compensation:
0: Disabled
1: Enabled
Reduction of the adjustable range for
voltage setting (synergic MIG/MAG).
The adjustable range for voltage trim can be
reduced by 0-50% of the synergic voltage. This
feature is used if the machine is locked in level 2
and disabled when "---" is displayed.
Reduction of the adjustable range for
current setting (MMA/synergic MIG/MAG)
or wire feed speed (manual MIG)
The adjustable range for current setting can be
reduced by 0-25% of the synergic current. This
feature is used if the machine is locked in level 2.
-key to exit the OPt-menu