Publicidad
Idiomas disponibles
Idiomas disponibles
For 2019 models
1. Remove bottom panel & lower fascia: (a) Using 10 mm socket, remove (4) bolts from the bottom panel, see Figure 6. (b) Using flat head screwdriver, remove (1)
plastic clip from the side of lower fascia, both sides, see Figure 7. (c) Gently unclip the tabs from the back side of fascia and detach the lower portion by pulling
rearward. (d) Using 10 mm socket, remove (4) flange nuts that attach the bottom panel to the end panel, see Figure 8. Return the bottom panel to owner.
2. Lower exhaust: Using 13 mm socket, remove (2) bolts that connect exhaust hanger bracket to the frame rails, per side. NOTE: Support exhaust before removing
exhaust hanger brackets.
3. Remove wiring: Using a flat head screwdriver, detach (3) vehicle wiring plastic fasteners from frame rails if present. NOTE: On Trailhawk models remove (2) factory
M14 bolts from the rear vertical and horizontal frame on each side. Keep them for reassembly.
4. Remove seam sealer: Using utility knife, remove the seam sealer near the mounting holes for proper fitment.
5. Adjust outside studs: Bend down the outside (2) studs on the end panel using pliers, see Figure 9.
6. Install hitch: (a) Feed the carriage bolts ① and spacers ② through square access hole using the pull wires ⑧ for both vertical and horizontal attachments, both
sides, see Figure 1 & 5. Leave pull wires attached. NOTE: On Trailhawk models only feed (1) vertical hardware through forward square slot and reuse (2) M14 bolts
removed in step 3. (b) Raise hitch into position, over the exhaust, and feed the pull wires through bracket slot. Remove pull wires and loosely install conical
washers ③, hex nuts ④, lock washers ⑦ (if needed), or M14 bolts (Trailhawk models only) to the hitch.
7. Tighten all ½-13 GR8 fasteners with torque wrench to 110 Lb.-Ft. (149 N*M) and all M14 CL 10.9 fasteners to 148 Lb.-Ft. (201 N*M)
8. Secure wiring: Use cable ties ⑥ to secure vehicle wiring to exhaust hanger bracket.
9. Trim lower fascia: Locate the center of lower fascia and trim the area as shown in Figure 6.
10. Reinstall exhaust hanger bolts, exhaust hanger bracket, muffler, plastic clips, and lower fascia back to vehicle.
©2015-2018 Horizon Global™ Corp - Printed in Mexico
C L
3.50"
3.75"
Figure 6
Figure 8
Proper torque is needed to keep the hitch
secure to the vehicle when towing.
Figure 9
Sheet 4 of 21
75998NP
Figure 7
10-10-18
Rev. E
Publicidad
