Batteries - Nilfisk-Advance Convertamatic 24 Serie Instrucciones De Uso

BATTERIES

If your machine shipped with batteries installed do the following:
•
Check that the batteries are connected to the machine (25 / 25a).
•
Turn ON the Key Switch (A) and check the Battery Indicator (D). If the gauge is completely
fi lled, the batteries are ready for use. If the gauge is less than full, the batteries should be
charged before use. See the "Charging The Batteries" section.
•
IMPORTANT!: IF YOUR MACHINE HAS AN ONBOARD BATTERY CHARGER REFER TO THE
OEM PRODUCT MANUAL FOR INSTRUCTIONS REGARDING SETTING THE CHARGER FOR
BATTERY TYPE (SEE CHART).
If your machine shipped without batteries installed do the following:
•
Consult your Authorized Nilfi sk-Advance dealer for recommended batteries.
•
Install the batteries by following the instructions below.
•
DO NOT install two 12 volt batteries in your machine. This affects the stability of the
machine.
•
IMPORTANT!: IF YOUR MACHINE HAS AN ONBOARD BATTERY CHARGER REFER TO THE
OEM PRODUCT MANUAL FOR INSTRUCTIONS REGARDING SETTING THE CHARGER FOR
BATTERY TYPE (SEE CHART).
WARNING!
Use extreme caution when working with batteries. Sulfuric acid in batteries can cause severe injury if allowed to contact the skin
or eyes. Explosive hydrogen gas is vented from the batteries through openings in the battery caps. This gas can be ignited by any
electrical arc, spark or fl ame. Do not install any lead-acid battery in a sealed container or enclosure. Hydrogen gas from overcharging
must be allowed to escape.
When Servicing Batteries...
* Remove all jewelry
* Do not smoke
* Wear safety glasses, rubber gloves and a rubber apron
* Work in a well-ventilated area
* Do not allow tools to touch more than one battery terminal at a time
* ALWAYS disconnect the negative (ground) cable fi rst when replacing batteries to
prevent sparks.
* ALWAYS connect the negative cable last when installing batteries.
CAUTION!
Electrical components in this machine can be severely damaged if the
batteries are not installed and connected properly. Nilfi sk-Advance, a qualifi ed
electrician, or the battery manufacturer should install batteries.
1 Remove the batteries from their shipping crate and carefully inspect them for
cracks or other damage. If damage is evident, contact the carrier that delivered
them or the battery manufacturer to fi le a damage claim.
2 Turn the Master Key Switch (A) OFF and remove the key.
3 Tip the recovery tank to the side, locked position. Remove the battery cables from
inside the battery compartment.
4 Your machine comes from the factory with enough battery cables to install four 6
volt batteries. Carefully lift the batteries into the battery compartment and arrange
them exactly as shown in FIGURE 1. Secure the batteries as close to the back of
the machine as possible.
5 Install the battery cables as shown. Position the cables so the battery caps can
be easily removed for battery service.
6 Carefully tighten the nut in each battery terminal until the terminal will not turn.
Do not over-tighten the terminals, or they will be very diffi cult to remove for future
service.
7 Coat the terminals with spray-on battery terminal coating (available at most auto
parts stores).
8 Put one of the black rubber boots over each of the terminals and connect the
Battery Pack Connector (25 / 25a).
revised 1/07
FORM NO. - 56041596 - Convertamatic
ENGLISH / A-9
AH/Rate MFG
180 DEKA(gel)
195 US
238 US / Trojan
180 Exide
200 Exide
24, 26, 28, 32 / BA 625, 725, 825 - A-9
™
Algorithm
6
4
4 / 1
51
21
FIGURE 1